minimalism
Less, but better
Raw size isn't enough
Omit needless words
Dieter Rams: As Little Design as Possible
Morioka Shoten
Minimum
A Book by John PawsonAdd Less
An Article by Cassidy WilliamsA few people have asked me what I did to make this [website] so fast.
The answer is: nothing.
I just didn't add anything to make it slow.I kept it simple.
The pages are pre-rendered.
The CSS is inlined.
I didn't add unnecessary javascript.
The work was done before you got there.Your websites start fast until you add too much to make them slow. Do you need any framework at all? Could you do what you want natively in the browser? Would doing it without a framework at all make your site lighter, or actually heavier in the long run as you create or optimize what others have already done?
Tanikawa House
A BuildingPhotos of the Tanikawa House, designed by architect Kazuo Shinohara.
Built in 1974, this summer house materializes the act of covering a piece of earth, making it an inhabitation only by means of a roof protecting the dirt soil of the ground. The house lies on a slope in a middle of a wood and grows through an exposed timber frame structure which supports a large pitched roof. Under the roof, a minimal section of the house located on a side hosts some specific living functions concentrated on two floors: a bathroom, a kitchen, a bedroom and a staircase. This section lies in parallel to the main “earth room” (or “summer room”) and overlooks it.
Do We Need This?
An ArticleUltimately this redesign has been a study in less, trying to dig deep and find out what it is I actually want for this site. A momentary visual “wow”, or quality content that is worthy of your attention? I decided on the latter, with less visual clutter it is far harder to try obscure bad or shallow writing behind a veneer of pretty images and effects. Posts may take longer to write but I hope this new design will push towards content that is worthy of your time.
The drop press
The virtue of thin sheet metal in giving the greatest glitter for a grain of gold was exploited in the earliest days of metallurgy. However, before the days of rolled sheet and drawn wire, most metal objects were made by hammering and were basically three-dimensional in form.
[In contrast] look at the simple drop press — it’s unmodulated blow striking in a single direction symbolizes much of nineteenth-century mechanized production. To make multiple stampings, stacks of very thin metal sheets were superimposed under the hammer, and the final profile with moderately high relief was gradually achieved as finished sheets were removed from the bottom and new ones added at the top.
When the drop press was used to shape large areas of thin sheet metal, the aesthetic qualities of the surface became divorced from the underlying substance, and decoration became independent of the body needed to support it. In any object there is a natural relationship between the surface and the bulk, that is, between its one-, two-, and three-dimensional aspects. The fakery involved in applying gold or silver playing on a solid copper object is quite different from the deception of an ornately stamped piece of thin sheet brass. Compare a magnificent ormolu furniture fitting or even a gilded plaster picture frame with a cheap lamp base embossed in thin sheet brass. In the former, the surface is simply and honestly applied for its optical effect alone; in the latter the fakery is fundamental for it is dimensionally misleading.