Not all the towers along a transmission line are identical. Look closely at a tower where the line makes a sharp turn and you will likely find it is wider and beefier than other towers along the route. The added strength and weight are needed to resist the unbalanced pull of the conductors, which might overturn an ordinary tower. These special towers are called deviation or angle towers.
The transmission-line tower everybody knows is an Erector Set latticework of steel girders and diagonal braces. The techniques for designing and building these towers are the same ones used in constructing steel bridge trusses or crane booms. The individual pieces can be made cheaply from rolled steel and then bolted together on the site. This last point is more important than it might seem: transporting a fully assembled tower 100 feet tall is an awkward and expensive business.
When poet William Blake wrote of "dark satanic mills", he couldn't have been looking at a steel mill because there were none in 1804. Nevertheless, when I visit a steel mill, Blake's phrase always comes to mind. With the heat and the pounding noise, the dust and smoke, and the red glow against the night sky, it's hard not to see these places as infernal. And yet the process of making steel also produces some of the most hauntingly beautiful images found anywhere in the world of industry.
Working from first principles, and working in a highly organized way seem to come naturally to him, but his personal design process is much less structured than the results might suggest. Although he can tightly organize his team and run a complex racing organisation, his personal ways of designing are relatively unstructured, based on annotated, thumb-nail sketches. ‘I don't sit down and say, OK, now I've had the idea, let's see, this is a solution, these are the different ways to go, if I do this, and do that; I do lots of scribbles just to save it, before I forget.’
Gordon’s design process is based on starting with a quick sketch of a whole idea, which is then developed through many different refinements. ‘I do a quick sketch of the whole idea, and then if there's one bit that looks good, instead of rubbing other bits out, I'd put that bit to one side; I'd do it again and expand on the good bit, and drop out the bad bit, and keep doing it, doing it; and end up with all these sketches, and eventually you end up throwing ninety percent of these away.’ He also talks to himself - or rather, writes notes to himself on the sketches; notes such as ‘rubbish’, ‘too heavy’ or ‘move it this way 30mm.’ Eventually he gets to the stage of more formal, orthographic drawings, but still drawing annotated plans, elevations and sections all together, ‘Until at the end of the day the guys at Brabham used to call them “Wonder Plots”, because they used to say “It's a wonder anybody could see what was on them”!’